AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Furnace Repair Across Irving
When your furnace quits in the middle of a cold snap, you need someone who knows Irving’s housing stock as well as the equipment inside it. Highpoint AC Repair handles furnace repair and furnace replacement for homeowners across Irving, from the older ranch homes in the south to the newer subdivisions up north, and our technicians have up to 11 years of experience with the brands that fill local mechanical closets. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Call (855) 752-3431 and we’ll get a technician headed your way.
Why Irving Homeowners Call Highpoint AC Repair for Furnace Repair
We work in every part of Irving, from the 1950s-era ranch homes near the old downtown core to the towers and subdivisions up around Las Colinas. That range matters, because the furnace failures we see on each side of the city look nothing alike. A technician who only knows tract homes will struggle in a mechanical room; one who only works commercial buildings misses the quiet clues in a closet air handler.
Our team is factory-trained across nine major brands, including Carrier, Trane, Lennox, and Goodman, so we’re already familiar with your system before we arrive. We don’t carry a single-brand bias, and we don’t hand off repair work to a subcontractor when installation is the bigger job. One call covers both heating and cooling, and that matters when a failing furnace turns out to be part of a larger comfort problem.
When you call, you get a real answer about timing and cost. Our technicians have up to 11 years of experience, and we hold every job to the Highpoint standard: the work isn’t finished until it’s done right, not just running. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Furnace Tune Up in Irving
A Furnace Tune Up in Irving makes the most sense in late fall, before the first hard freeze rolls down from the north, and a typical tune-up here runs $80 – $200. The visit covers more than a filter swap: we measure static pressure across the system, check the heat exchanger for cracks, test the ignitor and flame sensor, verify the blower motor draws, and confirm the thermostat is calibrated and calling for heat correctly. On older Irving homes with original ductwork, static pressure readings often reveal a restriction the homeowner never noticed.
What Gets Checked
Combustion safety, gas valve operation, flue draft, and the condition of the heat exchanger all get inspected. We also look at the blower compartment and capacitor, since a weak capacitor is a common cause of a furnace that runs but never quite heats the way it should.
When to Schedule
Book a tune-up before the heating season starts, or any time your furnace short-cycles, trips the limit switch, or just doesn’t feel as warm as it used to. A written report of what we found comes with every visit. Call (855) 752-3431 to schedule.
Emergency Furnace Repair in Irving
Emergency Furnace Repair in Irving usually means a no-heat call during a blue norther, when temperatures drop fast and a furnace that was fine last week won’t fire. Typical repair work runs $150 – $700, and we answer 24/7 with fast dispatch from 7am to 7pm, Sunday through Friday. If your call comes in outside those hours, we’ll book you into the next opening.
If your system has flooded, lost power, or taken a surge, don’t just flip the breaker and hope. A furnace that ran during an outage, or a heat pump condenser that iced over and then got restarted before the ice cleared, can suffer real damage on that first restart. We check the control board, capacitors, and safety switches before we bring anything back online, and we’ll tell you plainly whether it’s a repair or a replacement.
Storm and Outage Restarts
After a hard freeze or a power surge, the safest move is to leave the system off until a technician has looked at it. Older homes in south Irving with original wiring are especially vulnerable to surges that quietly damage control boards and capacitors.
No-Heat Calls
A furnace blowing cold air in the middle of winter is a health concern, not just an inconvenience. We prioritize no-heat calls and give you an upfront price before any work begins. Call (855) 752-3431.
Trusted Brands We Service in Irving
We’re certified to work on nine major HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. That cross-brand knowledge means our technicians already understand your equipment’s common failure points before they arrive. We don’t stock parts locally, but we source what’s needed quickly and get your furnace back up without a long wait. If you’ve struggled to find a contractor who knows your Trane or Goodman furnace, that’s exactly the kind of job we take on. Our furnace repair team handles diagnosis and repair, and we also cover furnace replacement when that’s the better call.
See the difference
Before
After
Before
After
Before
AfterCommon Furnace Repair Problems We See in Irving Homes
- Cracked heat exchangers in 1950s-70s ranches. Older south Irving homes with closet and attic air handlers often run original ductwork that’s undersized for the blower, and the resulting high static pressure stresses the exchanger over time. A cracked exchanger is a safety issue, not just a performance problem.
- Limit-switch trips from restricted airflow. A clogged filter combined with tight original ducts pushes static pressure past spec, and the furnace shuts down on the limit switch to protect itself. It’s one of the most common winter calls we get in older Irving homes.
- Control board and capacitor failures after a surge. Blue northers and generator changeovers can knock out furnace electronics in homes with older wiring. A furnace that won’t respond after an outage is often a board or capacitor issue.
- Freeze-and-thaw damage on outdoor equipment. Heat pump condensers and outdoor piping take a beating when a hard freeze hits and the unit is restarted before ice clears. That’s true on both residential lots and the rooftop DX units above Las Colinas towers.
Pricing for Furnace Repair in Irving, TX
Furnace repair in Irving typically runs $150 – $700, and a furnace tune-up runs $80 – $200. Those are estimated ranges for common work: ignitor replacement, gas valve repair, blower motor repair, and heat exchanger issues all fall within them depending on parts and the condition of your system. A simple ignitor swap sits at the low end. A blower motor replacement with a heat exchanger inspection sits closer to the top. The written estimate we give you sets the final price, and the estimate itself is free. If your system needs a major repair, we’ll also give you a straight comparison to furnace replacement, so you can decide with real numbers instead of a sales pitch. Call (855) 752-3431 for a free estimate.
We Also Serve Cities Near Irving
We handle furnace repair across the Irving area and into nearby communities including Grapevine, Carrollton, Dallas, and Lewisville. If you’re just outside Irving and need a technician who knows your equipment, we can help. Call (855) 752-3431 to confirm coverage and schedule a visit.
Serving Irving, TX – Our Local Coverage Area
We serve Irving and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Irving
No. Don’t restart a furnace or heat pump after a surge, flood, or hard freeze without a technician checking it first. Restarting a unit that took a surge or sat through an ice event can turn a cheap fix into a control board or motor replacement. Call (855) 752-3431 and we’ll take a look before anything gets powered back up.
Restricted airflow is almost always the cause. In older south Irving homes, a clogged filter paired with undersized original ductwork pushes static pressure past what the furnace is rated for, so it shuts down on the limit switch to protect the heat exchanger. A technician can measure static pressure and find the restriction before it becomes a crack. Call (855) 752-3431 for a diagnostic visit.
Repair fixes something that’s already failed, while a tune-up catches problems before they cause a no-heat call. Tune-ups in Irving run $80 – $200 and include a check of the heat exchanger, ignitor, blower, and thermostat. Repairs run $150 – $700 depending on the part. Call (855) 752-3431 to schedule either one.
Often yes. Las Colinas towers run rooftop and mechanical-room units with different controls, refrigerant systems, and access requirements than a residential furnace. Our technicians work both, so we can diagnose a rooftop unit and a closet air handler with the same level of familiarity. Call (855) 752-3431 to talk through what your building has.
It’s usually a heat pump issue rather than a furnace problem, though the two interact in a dual-fuel setup. Ice buildup after a hard freeze can mean a defrost cycle problem or a refrigerant charge issue, and restarting the unit before the ice clears can cause compressor damage. Call (855) 752-3431 and we’ll diagnose it properly.
Whether your furnace is short-cycling, tripping the limit switch, or just blowing cold air during an Irving cold snap, we’re ready to help. Our technicians have up to 11 years of experience and know the brands that fill Irving homes, from Carrier to Goodman to Trane. Call (855) 752-3431 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Highpoint AC Repair.